PN E101-2630

INSTRUCTIONS
Wear safety goggles to protect your eyes.
Wear Nitrile®, Neoprene® or PVC gloves to protect your hands.
Wear a long-sleeved shirt to protect your arms.

IMPORTANT! Read product Safety Data Sheet before use.

Setup
    1. Insert the applicator suction tube into sanitizer container.
    2. Attach BG Vehicle Sanitizing Applicator to shop air.
    3. Squeeze the trigger on the BG Vehicle Sanitizing Applicator and adjust the tip to achieve a fine mist. Tighten collar ring. NOTE: Adjusting the tip clockwise will increase the amount of sanitizer used.
Treat ratios: Average four door sedan: 4–6 fl. oz. (120–180 mL); full size SUV: 8–10 fl. oz. (235–295 mL); for HVAC systems: 2–4 oz. (60–120 mL). There will be some variability due to the size of the passenger vehicle as well as the spray technique of the individual performing the service.
Surface sanitizing and deodorization
    1. Remove soiled deposits from the surface to be treated. Open all the doors on the vehicle.
    2. Hold BG Vehicle Sanitizing Applicator at least 12 inches (30 cm) from surface and spray in a sweeping motion, covering all surfaces until wet. Spray door handles. Then, starting at the driver’s door and working your way around the vehicle, use a sweeping motion to spray surfaces: door panels, steering wheel, dashboard, HVAC controls, shifter knob, center console, seats, seatbelts and buckles, headliner, trunk, and floorboards. Allow surfaces to remain wet for 10 minutes.
      WARNING! Do not spray sanitizer directly on electronic displays, touchscreens, or in any orifices such as CD/cassette tape player, USB ports, aux cable ports, and SD card slots. Refer to the vehicle owner’s manual on how to clean these items properly.
HVAC system sanitizing
  1. Exterior: Set HVAC controls to fan mode on high. Close doors and spray sanitizer into fresh air vent.
  2. Interior: Open a door to gain access to the HVAC controls. Set HVAC to recirculate mode with the fan on high, and spray sanitizer into the recirculate intake vent. NOTE: The recirculate intake vent is usually located on the passenger side floorboard area.
  3. Close door and let the vehicle run for at least 10 minutes.
  4. After 10 minutes, open all the doors so the air in the compartment can be properly ventilated.
  5. Allow surfaces to air dry.
  6. Use a clean rag to remove any remaining visible residue.

NOTE: When the BG Vehicle Sanitizing Applicator is ready to be stored, place the suction tube inside a container with water and spray through the applicator to flush any residual product.

R01
©copyright 2020 BG Products, Inc. • Wichita, Kansas 67213