IMPORTANT! Read product Safety Data Sheet before use. Make sure BG Xpress® Power Steering Fluid Exchange System service hoses cannot get entangled with belts, fans and other moving parts of engine. This service exchanges hot fluids that may splash. Always wear protective gloves and side shield safety glasses while performing this service. Clean up any spills quickly to prevent slippery spots and possible fire hazards. Internal air regulator on this device is set at factory; do not attempt to adjust. Call your BG representative for service.

1. Place full container of BG power steering fluid into holder on top of BG Xpress® Power Steering Fluid Exchange System. Open container.
2. Place drain hose into used fluid container inside cabinet.
3. Close air valve (turn valve knob perpendicular to hose) on Control Block (C) and connect air source to BG Xpress.®
4. Place can of BG Quick Clean for Power Steering, PN 108, into holder on top of BG Xpress® and open can. Insert New Fluid Tube (N) and make sure it reaches bottom of can.
5. Attach long nylon wand to C3 connector on Control Block (C). Attach short nylon wand to C4 connector on Control Block (C).
6. Remove cap from vehicle power steering fluid reservoir and insert wands into reservoir. Long wand must reach bottom of reservoir. Short wand must reach inside of reservoir without touching fluid level. BG Xpress® will remove old fluid from bottom and add new fluid at top.

1. Set lever of Control Block (C) in middle of its range.
2. Open air valve (turn valve knob parallel to hose) on Control Block (C) to begin adding BG Quick Clean for Power Steering. Adjust reservoir fluid level by moving lever forward (–) to lower or back (+) to raise.
3. Close air valve (turn valve knob perpendicular to hose) on Control Block (C) when BG Quick Clean for Power Steering can is empty.
4. Remove wands from vehicle power steering fluid reservoir and replace cap.
5. Run engine for 15 minutes.
6. Turn steering wheel from stop to stop 3 to 4 times while engine is running to clean all components.

1. Remove New Fluid Tube (N) from BG Quick Clean for Power Steering can. Insert New Fluid Tube (N) into container of BG power steering fluid.
2. Remove cap from vehicle power steering fluid reservoir and insert wands.
3. Open air valve (turn valve knob parallel to hose) on Control Block (C) to begin exchange.
4. Turn steering wheel from it stop to stop 3 to 4 times during exchange to help remove all old fluid.
   Caution: Do not allow pump to growl continuously. Heat generated from this condition can damage vehicle and BG Xpress.®
5. Adjust Control Block (C) lever for proper fluid level. If exchange is faster than normal flow of fluid through reservoir, it can be slowed by turning air valve knob toward closed position.
6. Close air valve (turn valve knob perpendicular to hose) on Control Block (C) just before BG power steering fluid container is empty. Use remaining fluid to top off system as required.
7. Remove wands from vehicle power steering fluid reservoir and replace cap.