Set-up

1. Verify the tool is depressurized by pressing and holding the small pressure release button on top of the tool.
2. Remove the canister by turning it clockwise. If necessary, remove empty product can from the canister.
3. Inspect the canister and O-rings in the top of the tool for any signs of damage.
4. Open a new can of product with the opener located on the top of the trigger.
5. Place the open can into the canister.
6. Insert the sprayer top straw down into the can, align the three retainer pegs, and quarter-turn the canister counter-clockwise to lock it onto the sprayer top. When the canister is locked into place, external position indicators will align and an audible “click” may be heard.
7. Attach an air line with 80–125 psi to the air chuck on the tool handle.
8. Remove the air line after approximately 3 seconds.
9. The Universal Spray Applicator is ready to use!

Using the Universal Spray Applicator

1. With the product loaded and the tool pressurized, verify the spray nozzle is facing forward then simply point and spray by pressing the trigger down.
2. The tool will spray the entire can of product with a single air charge.
3. If more pressure is desired, the tool can be charged again.
4. Alternatively, the air line can be left on the tool for maximum pressure throughout the entire can of product.