BG AE04 Intake Adaptor, PN E101-2034


INSTRUCTIONS
Wear safety goggles to protect your eyes.
Wear Nitrile®, Neoprene® or PVC gloves to protect your hands.
Wear a long-sleeved shirt to protect your arms.

IMPORTANT! Read product Safety Data Sheet before use. Make sure this service is performed in a well-ventilated area.
CAUTION! Never use a throttle depressor to keep the engine above idle during service.
  1. Add BG Platinum® 44K® to fuel tank.
  2. For best results, add BG Platinum® 44K® to a full tank of gas. If the tank is not full, fill it up after the service.
  3. Fill supply tool with BG Platinum® Air Intake, Valve & Combustion Chamber Cleaner.
    CAUTION! This cleaner will damage paint and certain plastic materials.
  4. Verify the BG Intake Adaptor is tightly attached to the supply hose.
  5. Locate sensor, unplug it and set aside.

     

    If the engine is equipped with a metal intake, remove the vacuum hose shown below.

  6. Use a shop towel to remove any oil residue from inside the sensor port.
  7. Insert the adaptor into the open port.
  8. Rotate adaptor vent cap so arrow is pointing upward. Make sure air flow is not restricted and the holes on the adaptor remain uncovered.
  9. Start engine and allow vehicle to warm up to operating temperature.
  10. Install the BG Rev-It® (PN E101-4110) into the vehicle.  Follow the on screen instructions to ensure the vehicle is being revved to 3500 RPM throughout the Platinum service.  If the BG Rev-It® is not available, the vehicle MUST be revved manually following the “IMPORTANT” steps below!

    IMPORTANT!     While performing the service, rev the engine (snap throttle) quickly three times every 45 seconds to a target RPM of 3,500. This will ensure that any cleaner accumulation has cleared. If the vehicle revs cannot be raised above 2,500 RPM during the snap throttle or the vehicle does not return to idle, the service should not be performed.
    Warning! Failure to rev the vehicle during the service may result in engine damage!
  11. Open ball valve on supply hose.
  12. The adaptor will administer 22 oz. (650 mL) of cleaner in 25–40 minutes depending on engine vacuum. When supply tool is empty, close ball valve and allow the engine to idle for 15 minutes.
  13. Add a second 22 oz. (650 mL) can of cleaner to the supply tool and open the ball valve.
  14. When supply tool is empty, close ball valve and turn engine off.
  15. Remove the adaptor and reinstall sensor.
  16. Immediately test drive the vehicle for at least 15 minutes to clear any residual product. Clear any codes that may have set.
    Warning! Failure to test drive the vehicle after service may result in engine damage!